浏览全部资源
扫码关注微信
内轴箱悬挂高速动车组转向架抗倾覆稳定性研究
Research on the stability against overturning for EMU bogie with inner axle box suspension
- 机车电传动 2023年第1期 页码：72-77
- 作者机构：
西南交通大学 机械工程学院，四川 成都 610031
- 作者简介：
苏 瑞（1997—），男，硕士研究生，研究方向为车辆系统动力学；E-mail: shiruisu@163.com
- 基金信息：
DOI：10.13890/j.issn.1000-128X.2023.01.010
中图分类号： U292.91+4;U270.331纸质出版日期：2023-01-10，
收稿日期：2022-11-24，
修回日期：2023-01-01，
- 稿件说明：
扫 描 看 全 文
苏瑞, 付茂海, 李子昂, 等. 内轴箱悬挂高速动车组转向架抗倾覆稳定性研究[J]. 机车电传动, 2023(1): 72-77.
SU Rui, FU Maohai, LI Ziang,et al. Research on the stability against overturning for EMU bogie with inner axle box suspension[J]. Electric Drive for Locomotives, 2023(1): 72-77.
苏瑞, 付茂海, 李子昂, 等. 内轴箱悬挂高速动车组转向架抗倾覆稳定性研究[J]. 机车电传动, 2023(1): 72-77. DOI： 10.13890/j.issn.1000-128X.2023.01.010.
SU Rui, FU Maohai, LI Ziang,et al. Research on the stability against overturning for EMU bogie with inner axle box suspension[J]. Electric Drive for Locomotives, 2023(1): 72-77. DOI： 10.13890/j.issn.1000-128X.2023.01.010.
摘要
内轴箱转向架由于轴箱悬挂内置大幅度降低了车体的抗侧滚刚度，影响其运行性能。为提高其抗倾覆性能，内轴箱转向架通常采取安装抗侧滚扭杆和提高一系悬挂垂向刚度的措施。文章提出了一种抗倾覆装置，以提高内轴箱悬挂高速动车组转向架抗倾覆稳定性。该装置由2条互不连通的回路组成，安装在轮对轴箱和构架之间。在分析抗倾覆装置的基本原理、刚度特性和车辆动力学模型之后，利用MATLAB/Simulink软件，联合AMESim和SIMPACK软件进行联合仿真，得到车辆在不同速度条件下通过大半径曲线时的动力学性能和动态包络线。结果表明，采用抗倾覆装置可以在保证车辆运行稳定性的条件下大幅提高车体的抗侧滚能力，在车辆脱轨系数和轮轴横向力等安全性指标方面有着更优异的表现，同时有着较小的动态包络线。
Abstract
Due to the built-in axle box suspension
the EMU bogie with an inner axle box causes an obvious decrease in the anti-roll stiffness of the carbody and accordingly affects the running performance. The inner axle box bogie is usually accompanied with the measures of installing anti-rolling torsion bars and increasing the vertical stiffness of primary suspension
in order to improve the stability against overturning of the carbody. This paper proposed an anti-overturning device special for the EMU bogie with an inner axle box. It consisted of two disconnected circuits installed between the wheelset axle box and the frame. After analyzing the basic principle and stiffness characteristics of the anti-overturning device and vehicle dynamics model
co-simulation was performed to generate the dynamics performance and dynamic envelope of the vehicle passing large radius curves at various speeds by MATLAB/Simulink
AMESim and SIMPACK. The results show the effectiveness of the anti-overturning device to increase the anti-roll ability of the vehicle while maintaining the running stability
and the better safety indicators such as derailment coefficient and wheelset lateral force
in addition to a smaller dynamic envelope.
关键词
高速动车组内轴箱悬挂抗倾覆曲线动态包络线联合仿真轨道不平顺
Keywords
EMUinner axle box suspensionanti-overturningcurvedynamic envelopeco-simulationtrack irregularity
references
梁树林, 傅茂海. 内侧悬挂转向架在城轨车辆中的应用研究[J]. 铁道车辆, 2006, 44(4): 4-7.
LIANG Shulin, FU Maohai. Research on application of inside suspension bogies in urban vehicles[J]. Rolling Stock, 2006, 44(4): 4-7.
刘宇轩, 吴圣川, 李存海, 等. 轴箱内置型铁路车轴疲劳性能与寿命评估[J]. 交通运输工程学报, 2019, 19(3): 100-108.
LIU Yuxuan, WU Shengchuan, LI Cunhai, et al. Fatigue performance and life assessment of railway axle with inside axle box[J]. Journal of Traffic and Transportation Engineering, 2019, 19(3): 100-108.
郭峰, 刘建新, 吴圣川, 等. 轴箱布置方式对高速列车车轴承载性能的影响[J]. 机车电传动, 2022(1): 1-7.
GUO Feng, LIU Jianxin, WU Shengchuan, et al. Effect of journal arrangement on load-bearing capacity of high-speed train axles[J]. Electric Drive for Locomotives, 2022(1): 1-7.
WU B W, CHEN G X, LV J Z, et al. Effect of the axlebox arrangement of the bogie and the primary suspension parameters on the rail corrugation at the sharp curve metro track[J]. Wear, 2019, 426/427, Part B: 1828-1836.
邓铁松, 吴磊, 凌亮, 等. 轴箱内置与外置直线电机地铁车辆曲线通过性能对比[J]. 计算机辅助工程, 2015, 24(1): 12-17.
DENG Tiesong, WU Lei, LING Liang, et al. Comparison of curving performance of linear induction motor metro vehicles with inside and outside axle boxes[J]. Computer Aided Engineering, 2015, 24(1): 12-17.
贾洪龙, 尹振坤, 梁云, 等. 轨道车辆轴箱内置式转向架技术发展研究[J]. 城市轨道交通研究, 2021, 24(9): 59-63.
JIA Honglong, YIN Zhenkun, LIANG Yun, et al. Research on development of railway vehicle axle box in-board bogie technology[J]. Urban Mass Transit, 2021, 24(9): 59-63.
孙天助. 内侧轴箱式转向架动力学性能研究[D]. 成都: 西南交通大学, 2008.
SUN Tianzhu. Research on dynamics performance of the inner axlebox type bogie[D]. Chengdu: Southwest Jiaotong University, 2008.
梁云, 李文学, 王云朋. 轨道交通车辆抗侧滚结构形式的选型分析[J]. 城市轨道交通研究, 2017, 20(2): 20-24.
LIANG Yun, LI Wenxue, WANG Yunpeng. Type selection of anti-roll structural forms for rail transit vehicle[J]. Urban Mass Transit, 2017, 20(2): 20-24.
韩光旭, 韩庆利, 范军, 等. 一种轨道车辆抗侧滚装置的控制方法: CN202110048973.2[P]. 2021-01-14.
HAN Guangxu, HAN Qingli, FAN Jun, et al. A control method of anti-rolling device for rail vehicles: CN20211004
8973.2[P]. 2021-01-14.
姜建东, 付茂海, 李芾. 客车转向架抗侧滚扭杆装置特性分析[J]. 铁道机车车辆, 2004, 24(5): 4-7.
JIANG Jiandong, FU Maohai, LI Fu. Analysis of anti-roll torsion bar of passenger bogie[J]. Railway Locomotive & Car, 2004, 24(5): 4-7.
刘志远, 徐成祥, 张文康, 等. 轨道车辆用抗侧滚扭杆载荷计算方法[J]. 城市建设理论研究, 2017(34): 180.
LIU Zhiyuan, XU Chengxiang, ZHANG Wenkang, et al. Calculation method of anti-roll torsion bar load for rail vehicle[J]. Theoretical Research in Urban Construction, 2017(34): 180.
毕鑫, 罗世辉, 马卫华. 抗侧滚扭杆安装方式对城轨车辆曲线通过性能影响[J]. 机车电传动, 2011(6): 58-60.
BI Xin, LUO Shihui, MA Weihua. Impact of installing mode of anti-roll torsion bar to metro vehicle through the curve[J]. Electric Drive for Locomotives, 2011(6): 58-60.
李振乾, 池茂儒, 蔡吴斌, 等. 空气弹簧主动控制的摆式列车动力学性能研究[J]. 机车电传动, 2022(4): 89-96.
LI Zhenqian, CHI Maoru, CAI Wubin, et al. Research on dynamic performance of tilting train with active air spring control[J]. Electric Drive for Locomotives, 2022(4): 89-96.
陈盛钊, 钟义旭, 张邦基, 等. 液压互联悬架系统关键参数对车辆动力学响应影响及试验验证[J]. 机械工程学报, 2017, 53(14): 39-48.
CHEN Shengzhao, ZHONG Yixu, ZHANG Bangji, et al. Influence of key parameters of hydraulically interconnected suspension on vehicle dynamics and experimental validation[J]. Journal of Mechanical Engineering, 2017, 53(14): 39-48.
王爱彬, 滕万秀, 杨建龙. 抗侧滚扭杆刚度对地铁车辆动态限界的影响[J]. 铁道技术监督, 2017, 45(7): 38-41.
WANG Aibin, TENG Wanxiu, YANG Jianlong. Exploration of influence of anti-roll bar stiffness on dynamic clearance of subway vehicles[J]. Railway Quality Control, 2017, 45(7): 38-41.
0
浏览量
20
下载量
0
CSCD
1
CNKI被引量
- 网络PDF下载
- WORD下载
- Meta-XML下载
- BibTeX下载
- Endnote下载
- RefMan 下载
- NoteExpress下载
- NoteFirst下载
关联资源
相关文章
相关作者
相关机构
- 技术支持由北京北大方正电子有限公司提供 湘ICP备20010475号-1
京公网安备11010802024621 - 本系统建议在Chrome、 IE9+ 以上版本浏览器阅读本站内容，360浏览器请切换至极速模式
- Cookies帮助我们提供服务并提供个性化体验。使用本网站，即表示您同意我们使用Cookies