Study on abnormal abrasion of metro pantograph

ZHANG Shiyu; YANG Gang; LYU Kun; QIING Limu; LI Fu

doi:10.13890/j.issn.1000-128X.2023.04.102

您当前的位置：

首页 >

文章列表页 >

Study on abnormal abrasion of metro pantograph

Railway Electrification | 更新时间：2024-08-02

- Study on abnormal abrasion of metro pantograph
- Electric Drive for Locomotives Issue 4, Pages: 124-130(2023)
- 作者机构：
  
  1.中车长春轨道客车股份有限公司，吉林长春 130062
  2.西南交通大学机械工程学院，四川成都;610031
- 作者简介：
- 基金信息：
- DOI：10.13890/j.issn.1000-128X.2023.04.102
  CLC： U264.3⁺4;U231
- Published：10 July 2023，
  
  Received：07 September 2021，
  
  Revised：04 March 2022，
- 稿件说明：
扫描看全文
张士宇, 杨岗, 吕琨, 等. 地铁车辆受电弓异常磨耗研究[J]. 机车电传动, 2023(4): 124-130.

ZHANG Shiyu, YANG Gang, LYU Kun, et al. Study on abnormal abrasion of metro pantograph[J]. Electric drive for locomotives,2023(4): 124-130.
张士宇, 杨岗, 吕琨, 等. 地铁车辆受电弓异常磨耗研究[J]. 机车电传动, 2023(4): 124-130. DOI： 10.13890/j.issn.1000-128X.2023.04.102.

ZHANG Shiyu, YANG Gang, LYU Kun, et al. Study on abnormal abrasion of metro pantograph[J]. Electric drive for locomotives,2023(4): 124-130. DOI： 10.13890/j.issn.1000-128X.2023.04.102.

摘要

弓网系统是城市轨道交通列车供电的中枢系统。较高的列车速度和复杂的列车运行环境会导致受电弓网系统产生剧烈的振动，从而引发高频燃弧和弓网异常磨耗现象。为了探究弓网异常磨耗的机理，文章以某地铁线路为例，研究了各运行指标与弓网异常磨耗关系及各指标间的联系。首先，通过阐述弓网运行状态指标定义及计算公式，提出弓网异常磨耗主要影响指标的选取。搭建某地铁数据采集系统，获取地铁线路运行实测数据；其次，统计分析新旧滑板在不同工况下各个指标分布的规律和变化趋势，研究了各个指标之间的相关性；最后，采用时空维度关联分析法，基于同一工况分析各个指标在空间与时间两个维度上存在的内在联系与差异。研究结果表明：滑板与接触线磨合初期，由于未形成光亮氧化层以致接触不够稳定，导致弓网接触燃弧率增加，从而使得弓网燃弧率上升，但指标间变化趋势并不明显。随着滑板运行至稳定磨耗期，受电弓离线率、燃弧和硬点异常率存在较大的相关性，当其中有一项指标发生异常时，总伴随其余指标发生异常。异常磨耗的发生常伴随有弓网运行指标的异常，可通过对运行参数的监控，完成对弓网异常磨耗的监测和预防，为研究弓网异常磨耗机理提供了一种有效方法。

Abstract

Pantograph-catenary system is the central system for the power supply of urban rail transit trains. Higher train speed and complex train operating environment can generate severe vibrations on the pantograph-catenary system

resulting in high-frequency arcing and abnormal abrasion of pantograph. Taking the abnormal abrasion of the pantograph-catenary system in a metro project as an example

this paper studies the relationship between operation indicators and the abnormal abrasion of pantograph-catenary system

and correlations among the operation indicators. Firstly

this paper proposed the selection of indicators influencing the abnormal abrasion of pantograph-catenary system based on the definition of status indicator of pantograph-catenary operation and calculation formula. The data collection system of the metro line was established to obtain the measured data in the operation of the metro. Secondly

this paper statistically analyzed the distribution law and change trend of the indicators of old and new sliders under different working conditions

and studied the correlation among the indicators. Finally

under the same working condition

spatiotemporal dimension association analysis was used to analyze the internal connections and differences of each indicator in terms of space and time. The research results show that: in the early stage of running-in between the slider and the catenary

the arcing rate increases due to the lack of an oxide layer

which leads to an increase in the arcing rate of the pantograph-catenary contact

but the change trend between the indicators is not obvious. As the slider runs to a stable abrasion period

there is a strong correlation between the offline rate of the pantograph

arcing rate

and abnormal rate of the hard point. When one of the indicators is abnormal

it is always accompanied by the abnormality of the other indicators. The occurrence of abnormal abrasion is often accompanied by the abnormality of pantograph-catenary operation indicators. The monitoring and prevention of abnormal abrasion of pantograph-catenary can be completed by monitoring operation parameters

which provides an effective method for studying the mechanism of abnormal abrasion of pantograph-catenary.

关键词

城市轨道交通列车弓网系统磨耗燃弧拉出值地铁车辆

Keywords

urban rail transittrainpantograph-catenary systemabrasionarcingpull-out valuemetro vehicle

references

杨瀛瑜, 蒋聪健, 吕阶军. 高速受电弓弹性元件失效分析与结构优化[J]. 机车电传动, 2020(3): 115-117.

YANG Yingyu, JIANG Congjian, LYU Jiejun. Failure analysis and structural optimization for elastic element of high-speed pantograph[J]. Electric drive for locomotives, 2020(3): 115-117.

朱伟鹏. 深圳地铁11号线受电弓碳滑板磨耗率研究[J]. 铁道机车车辆, 2018, 38(4): 121-126.

ZHU Weipeng. Research on wear rate of pantograph carbon slide in Shenzhen Metro Line 11[J]. Railway locomotive & car, 2018, 38(4): 121-126.

刘秀美, 徐崎姝, 李亮, 等. 大连地铁1、2号线受电弓碳滑板异常磨耗研究[J]. 铁道机车与动车, 2020(4): 30-33.

LIU Xiumei, XU Qishu, LI Liang, et al. Study on abnormal wear of pantograph carbon contact strip for Dalian Metro Line 1 and 2[J]. Railway locomotive and motor car, 2020(4): 30-33.

吕文阁, 刘少册, 郑云龙, 等. 基于线结构激光的侧轨受电弓磨耗视觉测量系统开发[J]. 机车电传动, 2017(2): 114-117.

LYU Wenge, LIU Shaoce, ZHENG Yunlong, et al. Development of vision measurement system of side rail pantograph slide wear based on line structure laser[J]. Electric drive for locomotives, 2017(2): 114-117.

李岚, 郑东肪, 姚杰. 列车振动下接触网拉出值补偿算法[J]. 西南交通大学学报, 1999, 34(4): 457-460.

LI Lan, ZHENG Dongfang, YAO Jie. A compensation algorithm for the staggers of contact network under train vibration[J]. Journal of southwest jiaotong university, 1999, 34(4): 457-460.

陈宇, 肖国祥. 运行速度对接触网拉出值检测误差的影响[J]. 铁道机车车辆, 2007, 27(6): 62-65.

CHEN Yu, XIAO Guoxiang. Influence of running speed on measured error of stagger value of contact wire[J]. Railway locomotive & car, 2007, 27(6): 62-65.

杨家伟. 地铁受电弓强度及疲劳可靠性研究[D]. 成都: 西南交通大学, 2017.

YANG Jiawei. Study on strength and fatigue reliability of metro pantograph[D]. Chengdu: Southwest Jiaotong University, 2017.

张忠权. 接触网 “硬点” 成因和整治的思考与实践[J]. 电气化铁道, 2007(4): 36-38.

ZHANG Zhongquan. Causes of "hard point" of OCS and theory and practice for its elimination[J]. Electric railway, 2007(4): 36-38.

宋杰. 电气化铁路接触网硬点产生及防治措施[J]. 自动化与仪器仪表, 2017(3): 140-141.

SONG Jie. Electrified railway catenary hard point and control measures[J]. Automation & instrumentation, 2017(3): 140-141.

伍川辉, 卿云, 吴琛, 等. 地铁车辆接触网硬点在线检测系统设计[J]. 中国测试, 2020, 46(1): 77-82.

WU Chuanhui, QING Yun, WU Chen, et al. Design of on-line detection system of the hard point of catenary for metro vehicle[J]. China measurement & test, 2020, 46(1): 77-82.

KUBO S, KATO K. Effect of arc discharge on wear rate of Cu-impregnated carbon strip in unlubricated sliding against Cu trolley under electric current[J]. Wear, 1998, 216(2): 172-178.

蒲文旭, 于龙, 陈唐龙, 等. 基于熵测度的地铁弓网燃弧电流扰动分析[J]. 高电压技术, 2014, 40(11): 3642-3648.

PU Wenxu, YU Long, CHEN Tanglong, et al. Analysis of metro pantograph-catenary arc and current disturbance based on entropy measure[J]. High voltage engineering, 2014, 40(11): 3642-3648.

杨恒, 伍川辉, 吴琛. 基于图像处理弓网燃弧检测研究[J]. 铁道科学与工程学报, 2018, 15(4): 1030-1035.

YANG Heng, WU Chuanhui, WU Chen. The pantograph-catenary arc test research based on image processing technology[J]. Journal of railway science and engineering, 2018, 15(4): 1030-1035.

宋冬利, 江亚男, 张卫华. 滑板磨耗对受电弓系统服役性能的影响研究[J]. 西南交通大学学报, 2017, 52(3): 450-457.

SONG Dongli, JIANG Yanan, ZHANG Weihua. Effects of contact strips wear on service performance of pantograph system[J]. Journal of southwest jiaotong university, 2017, 52(3): 450-457.

赵汝彬. 受电弓滑板滑动电接触磨损特性的实验研究[D]. 阜新: 辽宁工程技术大学, 2009.

ZHAO Rubin. Experimental research on sliding electrical contact friction characteristics of pantograph contact strips[D]. Fuxin: Liaoning Technical University, 2009.

Views

下载量

CSCD

CNKI被引量

Alert me when the article has been cited

提交

Tools

Publicity Resources

Research on random vibration fatigue of high-voltage electrical box based on FKM standard

Multi-field coupling modeling and temperature rise analysis for the static pantograph-catenary electrical contact of metro trains

Dynamic Performance Analysis of Aluminum Matrix Composite Brake Disc for Linear Metro Vehicle

Auxiliary Power Supply System with Grid Connected Power Supply and High Frequency Converter Technology of Ningbo Rail Transit Vehicles

Study of Vehicle Pantograph-catenary Dynamic Performance Based on ADAMS

Related Author

LI Zhenping

LI Hua

BI Yonglei

WU Aizhong

WENG Lin

Kailei ZHOU

Wubin CAI

Maoru CHI

Related Institution

Zhuzhou CRRC Times Electric Co., Ltd.

School of Urban Railway Transportation, Shanghai University of Engineering Science

Shanghai Engineering Research Center for Vibration and Noise Control Technologies in Railway Transportation

State Key Laboratory of Traction Power, Southwest Jiaotong University

Jiangsu Kingway Rail Transit Equipment Co., Ltd.

⁰