WEN Yanfeng, WU Xiao, WANG Jian, et al. Research on special gauge of mountain rack railway[J]. Electric Drive for Locomotives,2023(3): 112-116. DOI: 10.13890/j.issn.1000-128X.2023.03.014.
Research on special gauge of mountain rack railway
The mountain rack rail transit system is a new type of rail transit system with the ability to operate on large ramps
and has been studied and promoted in multiple cities in China. At present
there is no directly applicable gauge standard for rack rail vehicles in China. The article took a Strub-type mountain rack rail vehicle as the research object
analyzed and provided a theoretical calculation formula for the special gauge of its bogie
and calculates the gauge. At the same time
dynamic simulation software was used to simulate the vehicle operation process to obtain the gauge. Finally
a comparison was made between the gauges obtained by the two calculation methods. The results indicate that the gauge calculated through theoretical formulas tends to be conservative and safer
making this method more suitable for engineering design. The research results of the article can provide reference for engineering design.
SHANG Qin, LI Lianfeng, TU Xu. Development and application of foreign cog railways and rack vehicles[J]. Electric Drive for Locomotives, 2019(2): 9-15.
SONG Qingwei, WANG Yunpeng, WANG Shiqiang, et al. Research of development and key technologies for mountainous rack railway[J]. Electric Drive for Locomotives, 2022(4): 77-82.
Department of Transportation of Sichuan Province. Technical specification for mountainous (toothed rail) rail transit: DB51/T 2542—2018[S]. Chengdu: Quality and Technology Supervision Bureau of Sichuan Province, 2018.
Ministry of Construction of the People's Republic of China. Standard of metro gauges: CJJ 96—2003[S]. Beijing: China Architecture & Building Press, 2003.
YU Haowei, ZHANG Yuwei, CHEN Li. Research on the technical characteristics and application prospect of the rack railway[J]. Journal of Railway Engineering Society, 2020, 37(10): 6-10.
NIU Yuecheng, LI Fu, DING Junjun, et al. Overview of mountain rack railway development and application[J]. Railway Standard Design, 2019, 63(12): 37-43.
XU Lin, LI Yifang, YIN Jianlei. Research on vehicle gauge of urban rail transit engineering[J]. Electric Locomotives & Mass Transit Vehicles, 2017, 40(6): 67-69.
LIU Wenlong, XU Yanhai, WU Xiao, et al. Research and analysis for vehicle gauge of suspension monorail transit[J]. Railway Locomotive & Car, 2016, 36(6): 90-95.
WU Xiao, WANG Jian, XU Yinguang, et al. Research on limit of suspended monorail transit based on dynamic simulation[J]. China High-Tech, 2018(2): 20-22.
ZHANG Xiaoming, SHEN Gang. Calculation method of dynamic envelope line for subway car with dynamic simulation[J]. Urban Mass Transit, 2012, 15(3): 38-40.
WANG Aibin, TENG Wanxiu, YANG Jianlong. Exploration of influence of anti-roll bar stiffness on dynamic clearance of subway vehicles[J]. Railway Quality Control, 2017, 45(7): 38-41.
State National Railway Administration of People's Republic of China. Specification for dynamic performance assessment and testing verification of rolling stock: GB/T 5599—2019[S]. Beijing: Standards Press of China, 2019.