ZHANG Xin, LI Jianwei, SHI Qinglu, et al. Study the influence of hydraulic shock absorber bidirectional ratio on dynamic performance of locomotive. [J]. Electric drive for locomotives (4):117-123(2022)
DOI:
ZHANG Xin, LI Jianwei, SHI Qinglu, et al. Study the influence of hydraulic shock absorber bidirectional ratio on dynamic performance of locomotive. [J]. Electric drive for locomotives (4):117-123(2022) DOI: 10.13890/j.issn.1000-128X.2022.04.017.
Study the influence of hydraulic shock absorber bidirectional ratio on dynamic performance of locomotive
为研究机车悬挂系统液压减振器双向比对机车动力学性能的影响,以某六轴宽轨机车为对象,利用Simpack软件建立了主要由车体、构架和轮对三大部分构成,共计90个自由度的车辆动力学模型,其中嵌入了减振器的非线性阻尼特性。在AAR 5级轨道谱的随机激励下,分别对减振器双向比大于1、等于1和小于1的阻尼模型所对应的机车动力学性能进行仿真分析。结果表明:当一系垂向减振器双向比为1时,直线工况下的机车垂向Sperling平稳性指标为3.08,加速度功率谱密度最大为0.11 m
In order to study the influence of bidirectional ratio of hydraulic shock absorber in locomotive suspension system on locomotive dynamic performance
a vehicle dynamic model with 90 degrees of freedom was established by using Simpack software
which consisted of body
frame
wheelset etc. The nonlinear damping characteristics of shock absorber were embedded. Under random excitation of AAR 5 track spectrum
the locomotive dynamic performance corresponding to the damping model with two-way ratio of shock absorber greater than
equal to and less than 1 was simulated and analyzed respectively. The results show that: When the bidirectional ratio of primary vertical shock absorbers is 1
the vertical Sperling stability index of the locomotive under linear working condition is 3.08
and the maximum acceleration power spectral density is 0.11 m
2
/s
3
both of which are smaller than the damping model with bidirectional ratio not 1
and the vibration transmission to the car body is more effectively attenuated. The vertical dynamic load coefficients of the primary and secondary suspension systems are minimum when the bidirectional ratio of the shock absorber is equal to 1
but they are not minimum when the vehicle speed is greater than 100 km/h. For the damping model with bidirectional ratio of 1
the anti-derailment coefficient of the locomotive and the vertical dynamic load coefficient of the secondary suspension device under curving conditions are better than that with bidirectional ratio greater than 1 or less than 1
but the vertical dynamic load coefficient of the primary suspension device is the largest. When the bidirectional ratio of the secondary transverse shock absorber is 1
the maximum nonlinear critical speed of the locomotive reaches 263 km/h
which is higher than that when the bidirectional ratio is greater than or less than 1. The research can provide some reference for the design of locomotive suspension system.
LI Xia, YANG Tao, ZHANG Jian, et al. Rail wear on the curve of a heavy haul line—Numerical simulations and comparison with field measurements[J]. Wear, 2016, 366/367: 131-138.
LI Chunsheng, LUO Shihui, COLE C, et al. Evaluation of primary suspension benefits for heavy haul wagons[J]. Journal of the China Railway Society, 2018, 40(8): 52-59.
WANG Chen, LUO Shihui, FAN Hui, et al. Influence of plateau locomotive suspension structure on vehicle vibration characteristics[J]. Journal of Vibration, Measurement & Diagnosis, 2018, 38(3): 583-589.
ZHOU Suxia, LU Shujuan, SUN Chenlong, et al. Simulation and research on damping characteristics of hydraulic damper for high-speed train[J]. Journal of the China Railway Society, 2019, 41(8): 50-55.
WANG W L, YU D S, HUANG Y, et al. A locomotive’s dynamic response to in-service parameter variations of its hydraulic yaw damper[J]. Nonlinear Dynamics, 2014, 77(4): 1485-1502.
ZHOU Suxia, QIN Zhen, SUN Chenlong, et al. Influences of common faults of anti-yaw damper on dynamic performances of high-speed train[J]. Journal of Beijing Jiaotong University, 2017, 41(1): 85-91.
ZHANG Ligang, LUO Yun, CHEN Guosheng. Dynamic performance analysis of HXD1 electric locomotive in fault state[J]. Electric Drive for Locomotives, 2009(4): 10-12.
YU Wentao, XU Chuanbo, GUO Zhaotuan, et al. Effect of troubles in secondary lateral damper on vehicle dynamic performance of CEMU[J]. Chinese Journal of Construction Machinery, 2019, 17(3): 252-255.
ZHANG Zhandong, ZENG Zhaoji. Improvement of the lateral stability of domestic quasi-high speed electric locomotive[J]. Electric Drive for Locomotives, 2012(1): 71-72.
FENG Zheng, YANG Liangliang, LUO Shihui. Influence of a C0-C0 locomotive secondary lateral damper on the lateral stability[J]. Electric Drive for Locomotives, 2016(2): 15-17.
SILVEIRA M, WAHI P, FERNANDES J C M. Effects of asymmetrical damping on a 2 DOF quarter-car model under harmonic excitation[J]. Communications in Nonlinear Science and Numerical Simulation, 2017, 43: 14-24.
YANG Yue, ZHANG Xiaofeng, ZHANG Zhaofeng, et al. Sensitivity analysis of railway vehicle suspension parameters on riding stability[J]. Journal of Railway Science and Engineering, 2014, 11(2): 116-120.
ZHAO Leilei, YU Yuewei, ZHOU Changcheng, et al. Effect of seat damper bidirectional ratio on impact dynamic behaviors of human-seat for logistic vehicles[J]. Journal of Beijing University of Posts and Telecommunications, 2018, 41(6): 14-19.
POLACH O, BÖTTCHER A. A new approach to define criteria for rail vehicle model validation[J]. Vehicle System Dynamics, 2014, 52(Suppl 1): 125-141.
LIU Hongyou, GAO Changjun, WANG Yunpeng, et al. Method to determine the critical hunting speed of bogies for 160 km/h rapid freight cars[J]. Rolling Stock, 2017, 55(6): 1-5.